Duct Leakage Test in Springfield, PA

Improve HVAC performance and ensure energy code compliance with dependable duct leakage test in Springfield, PA. Our certified technicians pinpoint and measure ductwork air leaks, helping homeowners and builders boost comfort, cut energy waste, and meet state compliance standards.

Why Duct Leakage Test is Important In Springfield, PA

Across many states and municipalities, the 2015 IECC, International Energy Conservation Code applies to single-family homes, while the 2018 International Energy Conservation Code governs multi-family buildings. The change will have some significant implications for home builders and HVAC contractors operating in the state. A Duct Leakage Test as well as a Blower Door Test in newly constructed or remodeled homes is now required in accordance with the 2015 regulations. Did you know that leaking ducts are a widespread cause of air loss in homes across Pennsylvania, New Jersey, and Delaware? Leaked air can cause your energy bills to rise, strain your HVAC system, and move dust and insulation around your living spaces. This makes duct leakage test indispensable no matter the age of your home. Continue reading to understand why duct leakage test is important and the benefits it provides.

888 213-3975

What Our Clients Say

How a Duct Leakage Test Is Conducted

To begin the process of a duct leakage test in Springfield, PA, your technician seals off all supply and return registers apart from the main return or air handler. A duct blaster — a specially calibrated fan — is then connected to the opening. It depressurizes the duct system to expose areas where air is leaking.

The duct blaster joins forces with a precision pressure sensor to monitor airflow and pinpoint leak points in the ducts without disturbing your home. A duct leakage test — often described as a duct blaster test — identifies leaking areas in your ducts so you can determine the most efficient sealing fix.

duct leakage test is quick, low-impact, and does not disturb residents. Most tests in Springfield, PA are completed in roughly 30 to 60 minutes, and the resulting enhancements can support your home’s comfort and efficiency long-term.

How to Measure Duct Leakage

Duct leakage is measured using cubic feet per minute (CFM) per 100 square feet of conditioned floor area. Your technician uses a nanometer to detect minimal pressure variations, revealing the amount of air leakage occurring in the duct system. Understanding this number helps you detect inefficiencies, assess needed upgrades, and ensure your home complies with local energy code requirements in Springfield, PA.

Cost of Excessive Duct Leakage

If elevated utility bills, shifting temperatures, or repeated HVAC issues occur in your home, duct leakage may be the factor behind them. According to ENERGY STAR, leaking ducts cause the average home to lose 20%–30% of conditioned air. Outside air that’s too hot or too cold entering your system strains your HVAC, resulting in higher energy consumption and less comfort.

Overworked equipment also produces more frequent issues that require costly repairs. Proper duct sealing helps keep your HVAC system healthy over the long run, prolonging its lifespan and lowering continued maintenance needs.

Duct leaks can also let in dust, mold spores, added moisture, and other harmful contaminants. This can heighten allergy issues, compromise indoor air quality, and slowly cause expensive structural damage behind walls or ceilings.

How to Properly Seal Ductwork in an Old Home

The 2015 IRC/IECC sets a requirement that all new homes feature ducts sealed completely with modern materials like mastic, foil tape, and insulation. But what if the leaks are buried far inside your walls or ceilings?

Aerosol sealing technology (AeroSeal) allows technicians to seal leaks located inside inaccessible parts of ductwork. To perform the process, technicians seal all vents but leave one access point open. The HVAC system is isolated, and a machine is connected to the duct system. It pressurizes the ducts and sends out a fine aerosol mist that seals tiny openings traditional sealing cannot reach.

This method works best for small to medium leaks. However, large openings usually require traditional manual sealing using mastic and tape. Technicians complete before-and-after duct leakage tests to measure leakage reduction and ensure the aerosol sealing was effective.

Common Areas of Duct Leakage

The most typical place where ducts leak air is at their joints. Ductwork is built from multiple metal sections pressed tightly with fittings and metal bands, yet these joints are rarely airtight.

As your HVAC system heats and cools during seasonal changes, the ductwork expands and then contracts. Over time, this movement allows the joints to loosen, producing gaps and leaks — which is why a duct leakage test is suggested for homes of all ages in Springfield, PA.

Many energy auditors locate duct leakage by touching the ductwork and using a small tool to measure the width of separation between joints. If your duct system hasn’t been finished with mastic and approved tape, leaks are highly likely.

What Is an Acceptable Amount of Duct Leakage per Energy Code?

To achieve a passing duct leakage result, your system is required to measure under 4 CFM per 100 square feet with the air handler installed, or 3 CFM per 100 square feet when it isn’t installed. For new construction, the duct leakage test must be passed prior to the home being approved for an occupancy certificate.

If your home in Springfield, PA doesn’t pass its duct leakage evaluation, you’re likely paying more for temperature control — and contributing to long-term HVAC strain. Meeting the 3–4 CFM requirement is significant not only for meeting local code but also for maintaining optimal comfort and efficiency in your home.

Your technician will also share expert recommendations for fixing leakage problems, helping you achieve a passing score, save on utilities, and improve home performance.

Local Energy Audits — affordable duct leakage test in Springfield, PA

Local Energy Audits is proud to serve families and builders across Springfield, PA and the surrounding local areas. We specialize in identifying and addressing duct leakage and energy inefficiencies using blower door tests and duct leakage tests. Whether you’re constructing a new home or optimizing an existing one, we’re here to help.
If you’d like to schedule a test, call us during business hours or contact us online to request an appointment.

The Duct Leakage Test Steps Explained

A duct leakage test begins by securing duct mask tape over every duct and register on the supply and return sides.

After the registers are sealed, we install the duct tester on the unit or on a main return.

The ducts are then brought to a depressurized pressure of 25 Pascals. Once depressurized, we use the nanometer for a leakage reading.

Schedule Your Duct Leakage Test in Springfield, PA

Ensure your HVAC system operates efficiently, stays compliant, and performs at peak levels with certified duct leakage test in Springfield, PA. Whether you’re a homeowner increasing comfort or a contractor completing a necessary inspection, our certified team offers fast, accurate, and affordable testing.

We use industry-standard duct blaster equipment and offer on-site guidance to help you pass your test, improve energy efficiency, and safeguard your HVAC system’s long-term health.

📞 Call 888-213-3975 ✉️ Request a Quote

Serving homeowners, builders, and contractors across Springfield, PA with dependable and energy-efficient testing solutions.