Duct Leakage Test in Tabernacle township, NJ

How a Duct Leakage Test Is Conducted

To start a duct leakage test in Tabernacle township, NJ, the technician will close and seal every supply and return register except the main return or air handler. A duct blaster — a specially calibrated fan — is then connected to the opening. It depressurizes the duct system to expose areas where air is leaking.

The duct blaster uses its precision pressure sensor partner to measure airflow and uncover duct leaks without causing any home disruption. A duct leakage test — also called a duct blaster test — locates the points where duct air escapes, helping you implement the right sealing solution.

duct leakage test is simple, clean, and minimally invasive for residents. Most tests in Tabernacle township, NJ are wrapped up in 30 to 60 minutes, with improvements that continue to boost comfort and efficiency for years.

How to Measure Duct Leakage

Duct leakage is rated in cubic feet per minute (CFM) per 100 square feet of the home’s conditioned zone. Your technician uses a nanometer to detect small pressure differences, which indicate how much air is leaking through the ducts. Understanding this number helps you pinpoint leakage points, think through potential improvements, and verify your home’s adherence to local energy code requirements in Tabernacle township, NJ.

Cost of Excessive Duct Leakage

If high utility expenses, irregular temperatures, or repeated HVAC troubles sound familiar, duct leakage might be the root cause. According to ENERGY STAR, duct leakage causes homeowners to lose 20%–30% of their conditioned air on average. When outdoor temperatures enter your system, the HVAC must work harder to compensate, resulting in higher energy costs and reduced comfort.

Overworked equipment also produces more frequent issues that require costly repairs. Proper duct sealing helps enhance the long-term resilience of your HVAC system, lengthening its lifespan and cutting overall maintenance needs.

Duct leaks can also bring dust, mold spores, excess moisture, and other impurities into the duct system. This can worsen allergies, reduce indoor air quality, and even cause expensive structural damage behind walls or ceilings over time.

How to Properly Seal Ductwork in an Old Home

The 2015 IRC/IECC requires new homes to have fully sealed duct systems using modern, energy-efficient materials such as mastic, foil tape, and insulation. But what happens when leaks are trapped deep inside wall or ceiling cavities?

Aerosol sealing technology (AeroSeal) is an effective solution for reaching hidden ductwork leaks. To implement this method, every vent is covered except one access point. The HVAC system is isolated, and a machine is connected to the duct system. It pressurizes the ducts and distributes a fine aerosolized sealant that seals small openings traditional methods cannot reach.

This method is very effective for minor to moderate leaks. However, substantial openings may still need traditional sealing with mastic and tape. Technicians complete before-and-after duct leakage tests to measure leakage reduction and ensure the aerosol sealing was effective.

Common Areas of Duct Leakage

The most typical location for air to escape from ducts is at the joints. Duct systems are built from multiple metal pieces pressed together with tight fittings and metal bands, but these joints are seldom completely airtight.

As your HVAC system transitions between warm and cool air throughout the year, the ducts expand and contract. Over time, this movement causes the joints to loosen, creating gaps and leaks — which is why a duct leakage test is recommended for both new and older homes in Tabernacle township, NJ.

Many energy auditors check duct leakage by feeling around the ducts and using a small tool to test the width of gaps between joints. If your duct system was never sealed using mastic and approved tape, there is a high probability that air leakage is present.

What Is an Acceptable Amount of Duct Leakage per Energy Code?

To achieve a passing duct leakage result, your system should stay under 4 CFM per 100 square feet with the air handler attached, or 3 CFM per 100 square feet without it. For new construction, you must pass a duct leakage test before the home can be approved for an occupancy certificate.

If your home in Tabernacle township, NJ fails duct leakage test, you are probably spending unnecessarily on heating and cooling — and placing ongoing stress on your HVAC equipment. Meeting the 3–4 CFM requirement is essential not only for code compliance but also for protecting your home’s energy efficiency and comfort.

Your technician will also give professional advice on resolving leakage issues to help you achieve a passing score, cut down utility bills, and boost your home’s performance.

Local Energy Audits — affordable duct leakage test in Tabernacle township, NJ

Local Energy Audits is proud to assist customers across Tabernacle township, NJ and its surrounding communities. We specialize in revealing duct leakage and energy inefficiencies through blower door and duct leakage test. Whether your project is new or existing, we’re here to assist.
If you’d like to book a test, call us during business hours or contact us online to request an appointment.